TM 5-3805-294-23-1
0016
Table 1. DTC 94.04 - Low-Pressure Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
4.
Clear and refresh DTCs. Note
if DTC 94.03 is now an active
DTC. (Volume 3, WP 0362)
5.
Turn key switch to OFF
1.
If DTC 94.03 is now an active
position (TM 5-3805-294-10).
DTC, proceed to Malfunction
8.
(Volume 5, WP 0794)
2.
If DTC 94.03 is not an active
DTC, proceed to Malfunction
12.
1.
Remove jumper wire from
8.
Check For DTC
engine interface wiring
94.04 With Engine
harness connector P03.
Interface Wiring
Harness Connector
(Volume 5, WP 0800, Figure
P03 Reconnected.
55)
2.
Connect engine interface
wiring harness connector P03
to the fuel transfer pump
pressure sensor. (Volume 5,
WP 0800, Figure 55)
3.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
4.
Clear and refresh DTCs. Note
if DTC 94.04 is now an active
DTC. (Volume 3, WP 0362)
5.
Turn key switch to OFF
1.
If DTC 94.04 is now an active
position (TM 5-3805-294-10).
DTC, replace fuel transfer
pump pressure sensor.
(Volume 5, WP 0794)
(Volume 3, WP 0431) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
2.
If DTC 94.04 is not an active
DTC, proceed to Malfunction
9.
1.
Turn key switch to ON position,
9.
Intermittent
but DO NOT START ENGINE
Connection.
(TM 5-3805-294-10). (Volume
5, WP 0794)
0016-5