TM 5-3805-294-23-1
0018
Table 1. DTC 97.03 - Water in Fuel Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Disconnect engine wiring
4.
Open Circuit
harness connector I01.
Between Engine
Interface Wiring
(Volume 5, WP 0800, Figure
Harness Connector
44)
I01 Pin 1 and
Ground.
2.
Measure resistance (Volume
1.
If greater than 5 ohms, replace
engine interface wiring
3, WP 0369) between engine
harness. (Volume 4,
interface wiring harness
connector I01 pin B (Volume 5,
WP 0509) Restore machine to
original condition and perform
WP 0800, Figure 44) and a
Harness Diagnostic Mode
known good ground. Note
reading.
Test. (Volume 3, WP 0345)
2.
If less than 5 ohms, replace
engine wiring harness.
(Volume 4, WP 0510) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
1.
Turn key switch to ON position,
5.
Short to Voltage
but DO NOT START ENGINE
Between Engine
(TM 5-3805-294-10). (Volume
Interface Wiring
Harness Connector
5, WP 0794)
D01 Sockets A and
B.
2.
Measure voltage (Volume 3,
WP 0369) between engine
interface wiring harness
connector D01 sockets A and
B. (Volume 5, WP 0800,
Figure 35)
3.
Turn key switch to OFF
1.
If greater than 5.5 volts,
position (TM 5-3805-294-10).
proceed to Malfunction 6.
(Volume 5, WP 0794)
If less than 5.5 volts, proceed
2.
to Malfunction 9.
1.
Disconnect engine wiring
6.
Engine Wiring
harness connector J03.
Harness Connector
J03 Has Damage or
(Volume 5, WP 0800, Figure
Loose Sockets.
48)
0018-3