TM 5-3805-294-23-1
0018
Table 1. DTC 97.03 - Water in Fuel Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 10 ohms, replace
14.
Open Circuit
Between Engine
3, WP 0369) between engine
ECU. (Volume 4, WP 0508)
Wiring Harness
wiring harness connector J03
Restore machine to original
Connector J03
socket H3 (Volume 5,
condition and perform Harness
Socket H3 and
Diagnostic Mode Test.
WP 0800, Figure 48) and
Engine Interface
engine interface wiring
(Volume 3, WP 0345)
Wiring Harness
harness connector D01 socket
2.
If greater than 10 ohms,
Connector D01
B. (Volume 5, WP 0800,
proceed to Malfunction 15.
Socket B.
Figure 35) Note reading.
1.
Disconnect engine wiring
15.
Open Circuit
harness connector I01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
44)
Socket H3 and
Engine Wiring
Harness Connector
I01 Socket 1.
2.
Measure resistance (Volume
1.
If less than 10 ohms, replace
engine interface wiring
3, WP 0369) between engine
harness. (Volume 4,
wiring harness connector J03
socket H3 (Volume 5,
WP 0509) Restore machine to
original condition and perform
WP 0800, Figure 48) and
Harness Diagnostic Mode
engine wiring harness
connector I01 socket 1.
Test. (Volume 3, WP 0345)
(Volume 5, WP 0800, Figure
2.
If greater than 10 ohms,
44) Note reading.
replace engine wiring
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
1.
Turn key switch to ON position,
16.
Intermittent
but DO NOT START ENGINE
Connection.
(TM 5-3805-294-10). (Volume
5, WP 0794)
2.
Select Readings and select
Connect to Model(s). (Volume
3, WP 0363)
3.
Select Dearborn Protocol
Adapter (DPA 4+) USB for the
Readings Adapter, and select
OK. (Volume 3, WP 0363)
0018-8