TM 5-3805-294-23-1
0018
Table 1. DTC 97.03 - Water in Fuel Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Remove jumper wire from
10.
Check For DTC
engine interface wiring
97.03 With WIF
harness connector D01.
Sensor
Reconnected.
(Volume 5, WP 0800, Figure
35)
2.
Connect engine interface
wiring harness connector D01
to the WIF sensor. (Volume 5,
WP 0800, Figure 35)
3.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
4.
Clear and refresh DTCs. Note
if DTC 97.03 is now an active
DTC. (Volume 3, WP 0362)
5.
Turn key switch to OFF
1.
If DTC 97.03 is now an active
position (TM 5-3805-294-10).
DTC, replace WIF sensor.
(Volume 5, WP 0794)
(Volume 3, WP 0454) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
If DTC 97.03 is not an active
2.
DTC, proceed to Malfunction
16.
1.
Disconnect engine wiring
11.
Engine Wiring
harness connector J03.
Harness Connector
J03 Has Damage or
(Volume 5, WP 0800, Figure
Loose Sockets.
48)
2.
Inspect sockets D2 and H3 on
1.
If damaged or has loose
engine wiring harness
sockets, replace engine wiring
connector J03 for damage and
harness. (Volume 4,
loose sockets. (Volume 5,
WP 0510) Restore machine to
WP 0800, Figure 48)
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 12.
0018-6