TM 5-3805-294-23-1
0018
Table 1. DTC 97.03 - Water in Fuel Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Inspect sockets D2 and H3 on
1.
If damaged or has loose
engine wiring harness
sockets, replace engine wiring
connector J03 for damage and
harness. (Volume 4,
loose sockets. (Volume 5,
WP 0510) Restore machine to
WP 0800, Figure 48)
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 7.
1.
Disconnect engine wiring
7.
Short Circuit
harness connector J01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
46)
Socket D2 and All
Other Sockets on
Engine Wiring
Harness
Connectors J03 and
J01.
2.
Measure resistance (Volume
1.
If any measurement was less
than 100 kohms, replace
3, WP 0369) between engine
engine wiring harness.
wiring harness connector J03
socket D2 and all other sockets
(Volume 4, WP 0510) Restore
on engine wiring harness
machine to original condition
connectors J03 (Volume 5,
and perform Harness
Diagnostic Mode Test.
WP 0800, Figure 48) and
(Volume 3, WP 0345)
J01. (Volume 5, WP 0800,
Figure 46) Note readings.
2.
If all measurements were
greater than 100 kohms,
proceed to Malfunction 8.
1.
Disconnect engine wiring
8.
Short Circuit
harness connector J02.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
47)
Socket D2 and All
Other Sockets on
Engine Interface
Wiring Harness
Connector J02.
0018-4