TM 5-3805-294-23-1
0019
TROUBLESHOOTING PROCEDURE
Table 1. DTC 97.04 - Water in Fuel Signal Out of Range Low.
Test or Inspection
Corrective Action
Malfunction
1.
Verify key switch is in OFF
1.
Engine Interface
position (TM 5-3805-294-10).
Wiring Harness
Connector D01 Has
(Volume 5, WP 0794)
Damage or Loose
Sockets.
2.
Disconnect engine interface
wiring harness connector D01
from WIF sensor. (Volume 5,
WP 0800, Figure 35)
3.
Visually inspect engine
1.
If damaged or has loose
interface wiring harness
sockets, repair connector D01
connector D01 for damage and
(Volume 4, WP 0511) or
loose sockets.
replace engine interface wiring
harness. (Volume 4,
WP 0509) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 2.
Visually inspect WIF sensor
1.
If damaged or has loose pins,
2.
Engine Interface
wiring harness connector
replace WIF sensor. (Volume
Wiring Harness
Connector D01 Has
(Volume 5, WP 0800, Figure
3, WP 0454) Restore machine
Damage or Loose
35) for damage and loose pins.
to original condition and
Pins.
perform Harness Diagnostic
Mode Test. (Volume 3,
WP 0345)
2.
If not damaged and does not
have loose pins, proceed to
Malfunction 3.
1.
Turn key switch to ON position,
3.
Check For DTC
but DO NOT START ENGINE
97.04 Active Status
(TM 5-3805-294-10). (Volume
Change With WIF
Sensor
5, WP 0794)
Disconnected.
2.
Clear and refresh DTCs. Note
if DTC 97.04 is still an active
DTC. (Volume 3, WP 0362)
0019-2