TM 5-3805-294-23-1
0019
Table 1. DTC 97.04 - Water in Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
3.
Turn key switch to OFF
1.
If DTC 97.04 is still an active
position (TM 5-3805-294-10).
DTC, proceed to Malfunction
9.
(Volume 5, WP 0794)
2.
If DTC 97.04 is not an active
DTC, proceed to Malfunction
4.
1.
Turn key switch to ON position,
4.
Check For DTC
but DO NOT START ENGINE
97.03 With WIF
(TM 5-3805-294-10). (Volume
Sensor Still
Disconnected.
5, WP 0794)
2.
Clear and refresh DTCs. Note
if DTC 97.03 is now an active
DTC. (Volume 3, WP 0362)
3.
Turn key switch to OFF
1.
If DTC 97.03 is now an active
position (TM 5-3805-294-10).
DTC, proceed to Malfunction
5.
(Volume 5, WP 0794)
2.
If DTC 97.03 is not an active
DTC, proceed to Malfunction
9.
Measure resistance (Volume
1.
If less than 100 kohms, replace
5.
WIF Sensor is
WIF sensor. (Volume 3,
Shorted to Ground.
3, WP 0369) between pin A or
pin B on the WIF sensor to a
WP 0454) Restore machine to
known good ground. (Volume
original condition and perform
Harness Diagnostic Mode
5, WP 0800, Figure 35) Note
reading.
Test. (Volume 3, WP 0345)
If greater than 100 kohms,
2.
proceed to Malfunction 6.
Measure resistance (Volume
1.
If between 200 and 240
6.
WIF Sensor Has
kohms, reconnect all
Internal Short.
3, WP 0369) between pin A
connectors and proceed to
and pin B on the WIF sensor.
Malfunction 7.
(Volume 5, WP 0800, Figure
35) Note reading.
2.
If not between 200 and 240
kohms, replace WIF sensor.
(Volume 3, WP 0454) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
0019-3