TM 5-3805-294-23-1
0019
Table 1. DTC 97.04 - Water in Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Measure resistance (Volume
1.
If less than 100 kohms, replace
engine interface wiring
3, WP 0369) between engine
harness. (Volume 4,
interface wiring harness
connector I01 pin 2 (Volume 5,
WP 0509) Restore machine to
original condition and perform
WP 0800, Figure 44) and a
Harness Diagnostic Mode
known good ground. Note
reading.
Test. (Volume 3, WP 0345)
2.
If greater than 100 kohms,
replace engine wiring
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
1.
Turn key switch to ON position,
16.
Check For DTC
but DO NOT START ENGINE
97.04 Active Status
(TM 5-3805-294-10). (Volume
Change With
Engine Wiring
5, WP 0794)
Harness Connector
J03 Disconnected.
2.
Clear and refresh DTCs. Many
new DTCs will be active, only
note if DTC 97.04 is still an
active DTC. (Volume 3,
WP 0362)
3.
Turn key switch to OFF
1.
If DTC 97.04 is still an active
position (TM 5-3805-294-10).
DTC, proceed to Malfunction
21.
(Volume 5, WP 0794)
2.
If DTC 97.04 is not an active
DTC, proceed to Malfunction
17.
1.
Disconnect engine wiring
17.
Short Circuit
harness connector J01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
46)
Socket D2 and All
Other Sockets on
Engine Wiring
Harness
Connectors J01 and
J03.
0019-8