TM 5-3805-294-23-1
0019
Table 1. DTC 97.04 - Water in Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Measure resistance (Volume
1.
If any measurement was less
than 100 kohms, replace
3, WP 0369) between engine
engine wiring harness.
wiring harness connector J03
socket D2 and all other sockets
(Volume 4, WP 0510) Restore
on engine wiring harness
machine to original condition
connectors J03 (Volume 5,
and perform Harness
Diagnostic Mode Test.
WP 0800, Figure 48) and
(Volume 3, WP 0345)
J01. (Volume 5, WP 0800,
Figure 46) Note readings.
2.
If all measurements were
greater than 100 kohms,
proceed to Malfunction 18.
1.
Disconnect engine interface
18.
Short Circuit
wiring harness connector J02.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
47)
Socket D2 and All
Other Sockets on
Engine Interface
Wiring Harness
Connector J02.
2.
Measure resistance (Volume
1.
If any measurement was less
than 100 kohms, replace
3, WP 0369) between engine
engine wiring harness
wiring harness connector J03
socket D2 (Volume 5,
(Volume 4, WP 0510) and
replace engine interface wiring
WP 0800, Figure 48) and all
harness. (Volume 4,
other sockets on engine
interface wiring harness
WP 0509) Restore machine to
connector J02. (Volume 5,
original condition and perform
Harness Diagnostic Mode
WP 0800, Figure 47) Note
readings.
Test. (Volume 3, WP 0345)
2.
If all measurements were
greater than 100 kohms,
reconnect all connectors and
proceed to Malfunction 19.
1.
Turn key switch to ON position,
19.
Intermittent Short
but DO NOT START ENGINE
to Ground.
(TM 5-3805-294-10). (Volume
5, WP 0794)
2.
Select Readings and select
Connect to Model(s). (Volume
3, WP 0363)
0019-9