TM 5-3805-294-23-1
0019
Table 1. DTC 97.04 - Water in Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
11.
Turn key switch to OFF
1.
If voltage fluctuated, replace
position (TM 5-3805-294-10).
engine wiring harness.
(Volume 5, WP 0794)
(Volume 4, WP 0510) Restore
machine to original condition
and perform Harness
Diagnostic Mode Test.
(Volume 3, WP 0345)
2.
If voltage did not fluctuate,
proceed to Malfunction 20.
1.
Turn key switch to ON position,
20.
Check DTC 97.04
but DO NOT START ENGINE
For Active Status.
(TM 5-3805-294-10). (Volume
5, WP 0794)
2.
Clear and refresh DTCs. Note
if DTC 97.04 is still an active
DTC. (Volume 3, WP 0362)
3.
Turn key switch to OFF
1.
If DTC 97.04 is still an active
position (TM 5-3805-294-10).
DTC, problem was not found
and may have been missed
(Volume 5, WP 0794)
during troubleshooting.
Restart procedure at
Malfunction 1.
2.
If DTC 97.04 is not active DTC,
problem corrected.
1.
Replace ECU. (Volume 4,
21.
ECU is Faulty.
WP 0508)
2.
Reconnect all connectors.
3.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
4.
Clear and refresh DTCs. Note
if DTC 97.04 is still an active
DTC. (Volume 3, WP 0362)
0019-11