TM 5-3805-294-23-1
0019
Table 1. DTC 97.04 - Water in Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Disconnect engine interface
10.
Open Circuit
wiring harness connector D01
Between Engine
from WIF sensor. (Volume 5,
Wiring Harness
Connector J03
WP 0800, Figure 35)
Socket D2 and
Engine Interface
Wiring Harness
Connector D01
Socket A.
2.
Measure resistance (Volume
1.
If less than 10 ohms, proceed
to Malfunction 12.
3, WP 0369) between engine
wiring harness connector J03
2.
If greater than 10 ohms,
socket D2 (Volume 5,
proceed to Malfunction 11.
WP 0800, Figure 48) and
engine interface wiring
harness connector D01 socket
A. (Volume 5, WP 0800,
Figure 35) Note reading.
1.
Disconnect engine wiring
11.
Open Circuit
harness connector I01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
44)
Socket D2 and
Engine Wiring
Harness Connector
I01 Socket 2.
2.
Measure resistance (Volume
1.
If less than 10 ohms, replace
engine interface wiring
3, WP 0369) between engine
harness. (Volume 4,
wiring harness connector J03
socket D2 (Volume 5,
WP 0509) Restore machine to
original condition and perform
WP 0800, Figure 48) and
Harness Diagnostic Mode
engine wiring harness
connector I01 socket 2.
Test. (Volume 3, WP 0345)
(Volume 5, WP 0800, Figure
2.
If greater than 10 ohms,
44) Note reading.
replace engine wiring
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
0019-6