TM 5-3805-294-23-1
0019
Table 1. DTC 97.04 - Water in Fuel Signal Out of Range Low - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 10 ohms, proceed
12.
Open Circuit
to Malfunction 14.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
2.
If greater than 10 ohms,
Connector J03
socket H3 (Volume 5,
proceed to Malfunction 13.
Socket H3 and
WP 0800, Figure 48) and
Engine Interface
engine interface wiring
Wiring Harness
harness connector D01 socket
Connector D01
B. (Volume 5, WP 0800,
Socket B.
Figure 35) Note reading.
1.
Disconnect engine wiring
13.
Open Circuit
harness connector I01.
Between Engine
Wiring Harness
(Volume 5, WP 0800, Figure
Connector J03
44)
Socket H3 and
Engine Wiring
Harness Connector
I01 Socket 1.
2.
Measure resistance (Volume
1.
If less than 10 ohms, replace
engine interface wiring
3, WP 0369) between engine
harness. (Volume 4,
wiring harness connector J03
socket H3 (Volume 5,
WP 0509) Restore machine to
original condition and perform
WP 0800, Figure 48) and
Harness Diagnostic Mode
engine wiring harness
connector I01 socket 1.
Test. (Volume 3, WP 0345)
(Volume 5, WP 0800, Figure
2.
If greater than 10 ohms,
44) Note reading.
replace engine wiring
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
Measure resistance (Volume
1.
If less than 100 kohms,
14.
Short Circuit
proceed to Malfunction 15.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
2.
If greater than 100 kohms,
Connector J03
socket D2 (Volume 5,
proceed to Malfunction 16.
Socket D2 and
WP 0800, Figure 48) and a
Ground.
known good ground. Note
reading.
1.
Disconnect engine wiring
15.
Short Circuit
harness connector I01.
Between Engine
Interface Wiring
(Volume 5, WP 0800, Figure
Harness Connector
44)
I01 Pin 2 and
Ground.
0019-7