TM 5-3805-294-23-1
0032
Table 1. DTC 110.03 - Engine Coolant Temperature Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Install jumper wire between
engine wiring harness
connector T04 sockets A and
B. (Volume 5, WP 0800,
Figure 69)
3.
Turn key switch to ON position,
but DO NOT START ENGINE.
(TM 5-3805-294-10) (Volume
5, WP 0794)
4.
Clear and refresh DTCs. Note
if DTC 110.04 is now an active
DTC. (Volume 3, WP 0362)
5.
Turn key switch to OFF
1.
If DTC 110.04 is now an active
position. (TM 5-3805-294-10)
DTC, proceed to Malfunction
9.
(Volume 5, WP 0794)
2.
If DTC 110.04 is not an active
DTC, proceed to Malfunction
10.
1.
Remove jumper wire from
9.
Check For DTC
engine wiring harness
110.03 With Engine
connector T04. (Volume 5,
Coolant
Temperature
WP 0800, Figure 69)
Sensor
Reconnected.
2.
Connect engine wiring
harness connector T04 to
engine coolant temperature
sensor.
3.
Turn key switch to ON position,
but DO NOT START ENGINE.
(TM 5-3805-294-10) (Volume
5, WP 0794)
4.
Clear and refresh DTCs. Note
if DTC 110.03 is now an active
DTC. (Volume 3, WP 0362)
0032-5