TM 5-3805-294-23-1
FIELD MAINTENANCE
DTC 655.06 - INJECTOR #5 CIRCUIT HAS LOW RESISTANCE
INITIAL SETUP:
References (cont.)
Tools and Special Tools
Tool Kit, General Mechanic's: Automotive
Volume 3, WP 0362
(Volume 5, WP 0796, Table 2, Item 119)
Volume 3, WP 0363
Accessory Kit, MSD Electronic Equipment
Volume 3, WP 0369
(Volume 5, WP 0796, Table 2, Item 2)
Volume 3, WP 0408
Multimeter, Digital
Volume 3, WP 0409
(Volume 5, WP 0796, Table 2, Item 77)
Volume 3, WP 0453
Probe Set, Standard
Volume 4, WP 0508
(Volume 5, WP 0796, Table 2, Item 91)
Volume 4, WP 0509
Test Set, MSD Electronic Systems
Volume 4, WP 0510
(Volume 5, WP 0796, Table 2, Item 116)
Volume 5, WP 0800
Personnel Required
Equipment Condition
Construction Equipment Repairer 91L (2)
Machine safely parked and shut down (TM
5-3805-294-10). (Volume 5, WP 0794)
Test Equipment Setup for MSD and Service
References
ADVISOR. (Volume 3, WP 0375)
TM 5-3805-294-10 (Volume 5, WP 0794)
Volume 3, WP 0345
Troubleshooting Sequence
DTC 655.06
When DTC is Displayed
The engine is cranking or running and the error condition is active. The DTC may also be displayed during HARNESS
DIAGNOSTIC MODE TEST in Service ADVISOR, provided fuel rail pressure is below 725 psi (5 MPa).
Related Information
The ECU detects low resistance in the cylinder #5 electronic injector circuit.
The ECU has two internally-connected terminals, which provide a shared high voltage supply to all the injectors.
The ECU switches the low side (ground) to control each individual injector.
This DTC can be caused by a wire-to-wire short. A short between the low side wiring of two injectors will cause active
DTCs indicating low resistance in both injectors.
This DTC can also be caused by an injector that has low coil resistance (coil windings are shorted together).
Alarm Level
Warning.
0087-1