TM 5-3805-294-23-1
0095
Table 1. DTC 898.09 - Engine Speed Request Not Received or Timed Out - Continued.
Test or Inspection
Corrective Action
Malfunction
4.
Turn key switch to OFF
1.
If DTC 898.09 is still active,
position (TM 5-3805-294-10).
replace ECU. (Volume 4,
(Volume 5, WP 0794)
WP 0508) Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
2.
If DTC 898.09 is not active,
problem corrected. Restore
machine to original condition.
Clear and refresh DTCs.
(Volume 3, WP 0362)
1.
Connect all connectors except
64.
connector X20. (Volume 5,
Between Connector
X20 Sockets 6 and 7
WP 0800, Figure 87)
Out Of Range.
2.
Measure resistance (Volume
1.
If between 110 - 130 ohms,
proceed to Malfunction 65.
3, WP 0369) between
connector X20 sockets 7 and
2.
If not between 110 - 130 ohms,
6. (Volume 5, WP 0800,
replace CAN terminating
Figure 87) Note reading.
resistor. (Volume 4,
WP 0506) Restore machine to
original condition. Clear and
refresh DTCs. (Volume 3,
WP 0362)
1.
Connect connector X20 to
65.
Check DTC 898.09
monitor controller. (Volume 5,
For Active Status.
WP 0800, Figure 87)
2.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
3.
Clear and refresh DTCs. Note
if DTC 898.09 is still active.
(Volume 3, WP 0362)
0095-20