• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Table 1. DTC 898.09 - Engine Speed Request Not Received or Timed Out - Continued
Table 1. DTC 898.09 - Engine Speed Request Not Received or Timed Out - Continued

Maintenance Manual For Hydraulic Excavator Type 1 With Hydraulic Thumb And Quick Latch -1 Page Navigation
  646    647    648    649    650  651  652    653    654    655    656  
img
TM 5-3805-294-23-1
0095
Table 1. DTC 898.09 - Engine Speed Request Not Received or Timed Out - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Disconnect terminating
54.
Short Circuit
resistor R10. (Volume 5,
Between MCF CAN
Wires.
WP 0800, Figure 60)
2.
Measure resistance (Volume
1.
If continuity is present, replace
cab wiring harness. (Volume 4,
3, WP 0369) between
connector X30 sockets 4 and
WP 0504) Restore machine to
original condition. Clear and
15. (Volume 5, WP 0800,
refresh DTCs. (Volume 3,
Figure 96) Note reading.
WP 0362)
2.
If continuity is not present,
proceed to Malfunction 55.
Measure resistance (Volume
1.
If continuity is present, replace
55.
Short Circuit
engine interface wiring
Between Engine
3, WP 0369) between engine
harness. (Volume 4,
Interface Wiring
interface wiring harness
Harness Connector
connector J02 sockets A1 and
WP 0504) Restore machine to
J02 Sockets A1 and
original condition. Clear and
B1. (Volume 5, WP 0800,
B1.
refresh DTCs. (Volume 3,
Figure 47) Note reading.
WP 0362)
2.
If continuity is not present,
proceed to Malfunction 56.
Measure resistance (Volume
1.
If continuity is present, replace
56.
Short Circuit
cab wiring harness. (Volume 4,
Between Connector
3, WP 0369) between
X34 Sockets 5 and
connector X34 sockets 5 and
WP 0504) Restore machine to
11.
original condition. Clear and
11. (Volume 5, WP 0800,
refresh DTCs. (Volume 3,
Figure 98) Note reading.
WP 0362)
2.
If continuity is not present,
proceed to Malfunction 57.
Measure resistance (Volume
1.
If continuity is present, replace
57.
Short Circuit
monitor controller wiring
Between Connector
3, WP 0369) between
harness. (Volume 4,
X20 Sockets 6 and
connector X20 sockets 6 and
7.
WP 0519) Restore machine to
7. (Volume 5, WP 0800,
original condition. Clear and
Figure 87) Note reading.
refresh DTCs. (Volume 3,
WP 0362)
If continuity is not present,
2.
proceed to Malfunction 58.
1.
Connect all connectors except
58.
Resistance
connector X30. (Volume 5,
Between Connector
X30 Sockets 4 and
WP 0800, Figure 96)
15 Out Of Range.
0095-17


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved.