TM 5-3805-294-23-1
0098
Table 1. DTC 1172.03 - Compressor Inlet Temperature Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Install jumper wire between
engine wiring harness
connector T06 sockets A and
B. (Volume 5, WP 0800,
Figure 71)
3.
Turn key switch to ON position,
but DO NOT START ENGINE.
(TM 5-3805-294-10) (Volume
5, WP 0794)
4.
Refresh DTCs. Note if DTC
1172.04 is now an active
DTC. (Volume 3, WP 0362)
5.
Turn key switch to OFF
1.
If DTC 1172.04 is now an
position. (TM 5-3805-294-10)
active DTC, proceed to
Malfunction 9.
(Volume 5, WP 0794)
2.
If DTC 1172.04 is not an active
DTC, proceed to Malfunction
10.
1.
Remove jumper wire from
9.
Check For DTC
engine wiring harness
1172.03 With
connector T06. (Volume 5,
Compressor Inlet
Temperature
WP 0800, Figure 71)
Sensor
Reconnected.
2.
Connect engine wiring
harness connector T06 to
compressor inlet temperature
sensor.
3.
Turn key switch to ON position,
but DO NOT START ENGINE.
(TM 5-3805-294-10) (Volume
5, WP 0794)
4.
Refresh DTCs. Note if DTC
1172.03 is now an active
DTC. (Volume 3, WP 0362)
0098-5