TM 5-3805-294-23-1
0100
Table 1. DTC 1347.03 - Suction Control Valve Signal Out of Range High - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Measure resistance (Volume
1.
If continuity is present, replace
3, WP 0369) between ECU
ECU. (Volume 4, WP 0508)
connector J01 on ECU pins H1
Restore machine to original
condition and perform Harness
and H2. (Volume 5, WP 0800,
Diagnostic Mode Test.
Figure 146) Note reading.
(Volume 3, WP 0345)
2.
If continuity is not present, it is
possible that another fault
exists or that another
troubleshooting procedure
applies. If this was the first time
through this procedure, restart
procedure at Malfunction 1.
END OF WORK PACKAGE
0100-8