TM 5-3805-294-23-1
0101
Table 1. DTC 1347.05 - Suction Control Valve Circuit Has High Resistance - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 1 kohm, replace
9.
Short Circuit
engine wiring harness.
Between Connector
3, WP 0369) between
Y01 Socket 1 and
connector Y01 socket 1 and a
(Volume 4, WP 0510) Restore
Ground With
known good ground. (Volume
machine to original condition
Engine Wiring
and perform Harness
5, WP 0800, Figure 115) Note
Harness Connector
Diagnostic Mode Test.
reading.
J01 Disconnected.
(Volume 3, WP 0345)
2.
If greater than 1 kohm,
proceed to Malfunction 10.
Measure resistance (Volume
1.
If continuity is present, replace
10.
ECU Faulty.
3, WP 0369) between ECU
ECU. (Volume 4, WP 0508)
connector J01 pins H1 and H2
Restore machine to original
condition and perform Harness
(Volume 5, WP 0800, Figure
Diagnostic Mode Test.
146). Note reading.
(Volume 3, WP 0345)
2.
If continuity is not present, it is
possible that another fault
exists or that another
troubleshooting procedure
applies. If this was the first time
through this procedure, restart
procedure at Malfunction 1.
1.
Disconnect engine wiring
11.
Engine Wiring
harness connector J01.
Harness Connector
J01 Has Damage or
(Volume 5, WP 0800, Figure
Loose Sockets.
46)
2.
Visually inspect engine wiring
1.
If damaged or has loose
harness connector J01 for
sockets, replace engine wiring
damage and loose sockets.
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 12.
0101-4