TM 5-3805-294-23-1
0101
Table 1. DTC 1347.05 - Suction Control Valve Circuit Has High Resistance - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 10 ohms, proceed
5.
Short Circuit
to Malfunction 6.
Between Connector
3, WP 0369) between
Y01 Socket 1 and
connector Y01 socket 1 and a
2.
If greater than 10 ohms,
Ground.
known good ground. (Volume
proceed to Malfunction 11.
5, WP 0800, Figure 115) Note
reading.
1.
Disconnect engine wiring
6.
Engine Wiring
harness connector J01.
Harness Connector
J01 Has Damage or
(Volume 5, WP 0800, Figure
Loose Sockets.
46)
2.
Visually inspect engine wiring
1.
If damaged or has loose
harness connector J01 for
sockets, replace engine wiring
damage and loose sockets.
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 7.
Visually inspect ECU
1.
If damaged or has loose pins,
7.
ECU Connector J01
connector J01 for damage and
replace ECU. (Volume 4,
Has Damage or
loose pins. (Volume 5,
Loose Pins.
WP 0508) Restore machine to
WP 0800, Figure 146)
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose pins, proceed to
Malfunction 8.
Measure resistance (Volume
1.
If less than 1 kohm, replace
8.
Short Circuit
engine wiring harness.
Between Connector
3, WP 0369) between
Y01 Sockets 1 and 2
connector Y01 sockets 1 and
(Volume 4, WP 0510) Restore
With Engine Wiring
machine to original condition
2. (Volume 5, WP 0800,
Harness Connector
and perform Harness
Figure 115) Note reading.
J01 Disconnected.
Diagnostic Mode Test.
(Volume 3, WP 0345)
If greater than 1 kohm,
2.
proceed to Malfunction 9.
0101-3