TM 5-3805-294-23-1
0123
Table 1. Engine Will Not Crank - Continued.
Test or Inspection
Corrective Action
Malfunction
Visually inspect connector V5
1.
If damaged or has loose
42.
Connector V5 Has
for damage and loose
sockets, replace cab wiring
Damage or Loose
harness. (Volume 4,
Sockets.
sockets. (Volume 5, WP 0800,
Figure 77)
WP 0504) Restore machine to
original condition.
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 43.
1.
Turn key switch to ON position,
43.
Ground is Present
but DO NOT START ENGINE
on Relay K4 Socket
(TM 5-3805-294-10). (Volume
2 With Diodes V4
and V5 Removed.
5, WP 0794)
2.
Measure resistance (Volume
3, WP 0369) between relay K4
socket 2 (Volume 5, WP 0800,
Figure 186) and a known good
ground. Note reading.
3.
Turn key switch to OFF
1.
If continuity is not present,
position (TM 5-3805-294-10).
replace cab wiring harness.
(Volume 5, WP 0794)
(Volume 4, WP 0504) Restore
machine to original condition.
2.
If continuity is present,
discontinue this
troubleshooting procedure and
perform procedure for Pilot
Shutoff Lever Does Not
Operate. (Volume 2,
WP 0185)
1.
Turn key switch to ON position,
44.
22 - 28 Volts Present
but DO NOT START ENGINE
Between Relay K35
(TM 5-3805-294-10). (Volume
Socket 1 and
Ground.
5, WP 0794)
2.
Measure voltage (Volume 3,
WP 0369) between relay K35
socket 1 (Volume 5, WP 0800,
Figure 213) and a known good
ground. Note reading.
0123-16