TM 5-2420-230-24-1
To prevent inadvertent movement of the FEL
arms when installing the maintenance arm,
CROSS COUNTRY DRIVING must be
selected on the driving mode switch. Failure to
comply may result in injury or death to
personnel.
If the FEL arms are required to be raised for
service work, the maintenance arm must be
fitted. Do not work under raised FEL arms
unless the maintenance arm is fitted. Failure to
comply may result in serious injury or death to
personnel.
Never work under vehicle raised by the FEL.
If the vehicle must be raised, place supporting
blocks under frame. Failure to comply may
result in serious injury or death to personnel.
(4)
To secure FEL arms, lower bucket to ground or
use travel stops and maintenance arm.
(5)
If engine is hot, run engine at idle speed without load for 2 min. to cool turbo.
Turn ignition switch to OFF to stop engine. Lock ignition switch in OFF position. Death or serious
injury may result if the unsupported vehicle moves unexpectedly during maintenance.
Never lubricate or service vehicle while it is moving. Keep hands, feet, and clothing clear of
moving parts. Failure to comply may result in serious injury or death to personnel.
If a maintenance procedure must be performed with the engine running, do not leave vehicle
unattended. Failure to comply may result in injury or death.
(6)
Unless otherwise specified, shut OFF engine and place electrical master switch in OFF position
(7)
Attach "Do Not Operate" tag to ignition switch (TM 5-2420-230-10).
