TM 5-2420-230-24-1
c. Installation.
Wear protective goggles, face shield, and gloves when working with glass. Failure to comply may
result in injury or death to personnel.
Adhesives, solvents, and sealing compounds burn easily and give off vapors that are harmful to the
skin and clothing. To avoid injury or death, keep away from open fire when using these materials,
and use only in well-ventilated areas. If adhesives, solvents, or sealing compounds contact the skin
or clothing, wash immediately with soap and water, and rinse thoroughly. Failure to comply may
result in injury or death to personnel.
NOTE
The installation procedures are the same for all window glass.
To install window glass, perform Steps (1) through (11).
Individual window glass is not to be replaced on left-side window assembly, right-side window
assembly, or rear window assembly. These assemblies are assembled in the factory as complete
units. If assembly glass must be replaced, replace the entire window assembly. To install left-side
window assembly, right-side window assembly, or rear window assembly, perform Steps (1)
through (11).
Ensure adhesive application is uniform and has no gaps. Adhesive should be 0.3 in. (8 mm) wide
and 0.5-0.6 in. (12-15 mm) high.
(1)
Remove all material down to the pinch weld.
(2)
Clean cabin frame (2) with Sikaflex 205 cleaner.
Change 1
13-37