TM 5-2420-230-24-1
(3)
Install two flexible draw latches with four bolts.
(4)
If removed, install six new threaded inserts.
(5)
Install two hinges on hood with six bolts.
(6)
Install upper end of hood struts with two nuts.
d. Installation.
(1)
Place hood in position.
(2)
Install six bolts, washers, and new self-locking nuts in hinges on frame.
(3)
Install lower end of hood struts with two nuts. Tighten nuts.
e. Follow-On Maintenance.
(1)
Close hood (TM 5-2420-230-10).
(2)
Remove "Do Not Operate" tag from ignition switch (TM 5-2420-230-10).
END OF TASK
13-20. GENERAL SHEET METAL REPAIR.
This Task Covers:
a. Dents
b. Cracks or Breaks
c. Follow-On Maintenance
INITIAL SETUP
Test Equipment
Equipment Conditions
None
TM or Para
Condition Description
Vehicle positioned on level
ground.
Tools and Special Tools
Tool kit, general mechanics, Item 38, Appendix B
Parking brake applied.
Tool kit, welders, Item 40, Appendix B
Engine shut OFF.
Electrical master switch OFF.
"Do Not Operate" tag attached
Materials/Parts
None
to ignition switch.
Personnel Required
Drawings Required
MOS 62B, Construction Equipment Repairer
None
References
Estimated Time to Complete Task
TC 9-237
None
a. Dents.
Straighten minor body dents by bumping with a soft-faced hammer while using a wooden block backing.
Change 1