TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 5
Remove front cover and forward and 2nd clutch.
Figure 8
Input shaft, rear bearing, drive gear and snap ring.
Figure 6
Figure 9
Use a spreading type snap ring pliers to spread the ears on for-
Install input shaft into front bearing.
ward clutch front bearing retainer ring. Remove forward clutch
with pry bar.
Figure 10
Figure 7
Support converter housing with chain fall. Spread forward
If input shaft is to be removed, tap on threaded end of shaft,
clutch front bearing retainer ring and tap forward and 2nd clutch
remove input shaft, gear and bearing.
assembly into transmission case assembly. Be certain snap ring
is in full position in ring groove.
See cleaning and inspection page.
--75--
F-120