TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 14
Figure 11
Support front cover with a clain fall. Install alignment studs in
Install 2nd speed clutch pilot bearing.
transmission case. Position front cover assembly on aligning
studs. Turn output flange to align clutch disc hub in clutch. Do
not force this operation. With front cover in position against the
transmission case install cover to case bolts. Tighten to
specified torque.
Figure 12
Install transmission case gasket and "O" ring seals.
Figure 15
Install front cover plug.
Figure 16
Figure 13
Install companion flange, flange "O" ring, washer and nut. Tor-
Install housing spacer, gasket and "O" ring seals. NOTE: Hous-
que nut to specified torque. (See elastic stop nut torque chart).
ing spacer is used with 12 plate clutch modulation only.
--76--
F-121