TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 21
Position pilot bearing on fourth speed clutch shaft. Install fourth
Figure 18
clutch on disc hub. Use caution as not to damage the pilot
Install end plate retainer ring. See transmission reassembly
bearing.
on page 38.
CONVERTER HOUSING INSTALLATION
4TH SPEED CLUTCH INSTALLATION
(8 speed only)
Figure 22
Support converter housing with a chain fall. Spread fourth
clutch front bearing retainer ring. Position converter housing to
transmission case assembly. Tap housing into place using
Figure 19
caution as not to damage any of the clutch shaft piston rings.
Position 4th speed clutch disc hub on idler shaft.
Figure 23
Spread forward clutch front bearing retainer ring to allow the
Figure 20
converter housing to position properly.
Install disc hub retainer ring.
--96--
F-142