TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
Figure 25
Use the same procedure for the forward clutch as explained in
Figure 24
Figure 24. Be certain both snap rings are fully seated in the
A hammer puller was used to pull the fourth clutch bearing
bearing snap ring grooves. Install converter housing to
forward to engage the front bearing snap ring in the bearing
transmission housing cap screws, tighten to specified torque.
groove.
REFER TO PAGE 46 FOR COMPLETE TRANSMISSION REASSEMBLY.
--97--
F-143