TM 5-2420-230-24-1
Maintenance & Service Manual
R & HR32000 3 & 6 Speed LD
DRIVE PLATE INSTALLATION
SUBJECT: 28000/32000 Series Transmission and C-270/C-320 Series Converter Drive Plate Kits. REASON
FOR BULLETIN: Proper Identification by Bolt Circle Diameter.
Measure the `"A" dimension (Bolt Circle diameter) and order Drive Plate Kit listed below.
"A" Dimension (Bolt Circle Diameter)
13.125" [333,375 mm] Diameter
Kit No.802335
13.50'" [342,900 mm] Diameter Kit
No.802333
17.00" [431,800 mmJ DiameterKit
No.802454
Each kit will include the following parts:
4 Intermediate Drive Plates
1 Drive Plate and Weld Nut Assembly.
1 Backing Ring.
10 Screw and Lockwasher Assembly.
1
Instruction Sheet.
TO FACILITATE ASSEMBLY, ALIGN SMALL HOLES IN DRIVE PLATES-SEE ILLUSTRATION ABOVE.
Position drive plate and weld nut assembly on impeller cover with weld nuts toward cover. Align intermediate drive plate and backing ring with holes in
impeller cover. NOTE: Two dimples 180 apart in backing ring must be out {toward engine flywheel). Install capscrews and washers. Tighten 23 to 25 ft.
lbs. torque [31,2-33,8 N.mJ
SEE PAGE 91 FOR TRANSMISSION TO ENGINE
INSTALLATION PROCEDURE
-98
