TM 5-2420-230-24-2
Section 14 - Engine Testing - Group 14
Engine Dynamometer Test - Installation of the Engine (14-01)
B Series Shop Manual
Page 14-11
If an external pressure pump is not available, prime the
lubricating system according to the following procedure.
Fill the engine with oil to the high level mark on the
dipstick.
Disconnect the turbocharger lubricating oil supply tube.
Pour 50 cc to 60 cc [2.0 fl.oz. to 3.0 fl.oz.] of clean 15W-40
oil into the turbocharger oil supply hole.
Connect the oil supply tube to the turbocharger.
Caution: Mechanical over-tightening can distort the
threads or damage the filter element seal.
Fill the lubricating oil filter with clean 15W-40 oil.
Screw the filter onto the filter head fitting until the gasket
contacts the filter head surface.
Tighten the filter according to the manufacturer's
specifications.
To make sure the lubricating oil pump is providing ade-
quate oil to the engine, first disconnect any wires leading
to the fuel pump solenoid.
L-441