TM 5-2420-230-24-2
Crankshaft Wear Sleeve, Rear (001-067)
B3.9 and B5.9 Series Engines
Page 1-112
Section 1 - Cylinder Block - Group 01
Inspect the rear cover for cracks or other damage.
Install (001-067-026)
NOTE: Do not use any kind of lubricant to install the seal.
The oil seal must be installed with the lip of the oil seal and
the crankshaft clean and dry to be sure of proper oil sealing.
Clean the lip of the oil seal of any existing lubricant.
NOTE: The combination crankshaft oil seal (A) wear sleeve
(B) replacement kit for service usage is installed on the
crankshaft as an assembly. The crankshaft rear oil seal
should not be removed from the crankshaft rear seal wear
sleeve.
Install the rear cover and gasket.
Install the rear cover capscrews. Do not tighten.
NOTE: If the oil pan is installed, loosen the oil pan capscrews
to allow clearance for rear cover and gasket clearance.
NOTE: The seal installation is being used to align the rear
cover properly. Do not push or force the cover in any
direction to prevent irregular seal lip position after seal
installation.
L-790
