TM 5-2420-230-24-2
Crankshaft Wear Sleeve, Rear (001-067)
B3.9 and B5.9 Series Engines
Page 1-110
Section 1 - Cylinder Block - Group 01
Disconnect the driveline, and remove the transmission, if
equipped. Refer to the OEM service manual.
Remove (001-067-002)
19 mm
Remove the clutch and flywheel, if equipped.
Refer to Procedure 016-005 and the OEM service manual.
Remove the flywheel housing.
Refer to Procedure 016-006.
Loosen the lubricating oil pan mounting capscrews four
revolutions.
CAUTION
Use extreme care when releasing the oil pan gasket
from the rear cover to prevent damage to the gasket.
Remove the four lubricating oil pan mounting capscrews
that secure the oil pan to the rear cover.
Insert a feeler gauge or shim stock between the rear cover
and the oil pan gasket. Move the feeler gauge or the shim
stock back and forth to release the gasket from the rear
cover.
If the gasket is damaged, the oil pan must be removed and
the gasket replaced. Refer to Procedure 007-025.
10 mm
Remove the capscrews from the rear cover, and remove the
cover from the crankshaft flange.
Remove the seal from the rear cover.
L-788
