TM 5-3805-280-10
Maintenance--Every 2000 Hours
17. Install suction screen with cover. Suction screen must
seal against outlet pipe in bottom of tank. If
necessary, loosen nut (B) to adjust rod length
Suction Screen Rod--Specification
Length (A)...................................................................... 670 mm (26.4 in.)
Suction Screen Rod Nut--Specification
Torque (A) .................................................. 17 Nm (12.5 lb-ft) (150 lb-in.)
Top of Rod to Top of Rod Nut--Specification
Length (C) ......................................................................... 20 mm (0.8 in.)
Cover Cap Screw--Specification
Torque ............................................................................. 49 Nm (36 lb-ft)
18. Install tank drain plug and bottom guard.
19. Add oil until it is between marks on sight glass. (See
Fuels and Lubricants chapter.)
TX,OUOE042,29
1908MAR996/7
IMPORTANT: If the hydraulic pump is not filled with
oil, it will be damaged when the engine
is started.
20. Remove air bleed plugs (C) from hydraulic pump until
oil flows from bleed holes.
21. Install air bleed plugs in hydraulic pump.
22. Check oil level in sight glass. Add oil, if necessary.
Install tank cap. Tighten vent plug.
23. Purge air from cylinders and swing motor by cycling
hydraulic functions.
TX,OUOE042,29
1908MAR997/7
17-8