TM 5-3805-280-24-2
Cylinder Block, Liners, Pistons and Rods
10
2. If necessary to replace bushing, remove bushing and
44
measure bore diameter in block. If bushing bore (B) in
block is not within specification, repair or replace
cylinder block as required.
3. Measure remaining camshaft bores in block and
compare with specification given. Repair or replace
cylinder block as required.
Camshaft Bore in Block, Front No. 1 (Without Bushing)--
Specification
ID ............................................................................... 59.961--59.987 mm
(2.3607--2.3617 in.)
A--Bushing Bore
Camshaft Bore in Block, Front No. 1 (With Bushing)--Specification
ID ............................................................................... 55.961--55.987 mm
(2.2031--2.2042 in.)
Camshaft Bore in Block (All Except No. 1)--Specification
ID ............................................................................... 55.986--56.012 mm
(2.2042--2.2052 in.)
Camshaft Journal-to-Bushing (No. 1 Bore With
Bushing)--Specification
Oil Clearance................................................................. 0.063--0.115 mm
(0.0025--0.0045 in.)
Camshaft Journal-to-Bushing (All Except No. 1)--Specification
Oil Clearance................................................................. 0.088--0.140 mm
(0.0035--0.0055 in.)
RG,10,DT7399 1911NOV972/2
13-157