TM 5-3805-280-24-2
Cylinder Block, Liners, Pistons and Rods
10
NOTE: Due to the manufacturing process, Precision
60
JointTM rod and cap both have a groove, while the
bearing insert has a single tang. Only the groove
in the cap is used for the bearing tang.
5. Install bearing insert in connecting rod cap with tang
(A) in groove (B).
IMPORTANT: On Precision JointTM connecting rods,
make sure cap is properly aligned on
rod with edges flush and interlocking
surfaces sealed tightly.
Tongue-and-Groove Rod
6. Apply clean engine oil to bearing insert. Install cap on
connecting rod with tangs to same side.
Precision JointTM Rod
A--Tang
B--Groove
C--Extra Groove (Not Used)
Precision Joint is a trademark of Deere & Company
Continued on next page
RG,10,DT7387 1911NOV974/5
13-173