TM 5-3805-280-24-2
Camshaft, Balancer Shafts and Timing Gear Train
16
NOTE: Flange on wear sleeve should be seated against
59
crankshaft drive gear when properly installed.
3. Position installation tool (B), provided in front wear
sleeve kit, over wear sleeve. Install wear sleeve using
a dead blow hammer until tool bottoms on nose of
crankshaft.
4. Clean any sealant from OD of crankshaft flange (C)
and wear sleeve.
B--Wear Sleeve Tool
C--Crankshaft Flange
Continued on next page
RG,16,DT7470 1914NOV973/4
13-291