TM 5-3805-280-24-2
Camshaft, Balancer Shafts and Timing Gear Train
INSTALL TIMING GEAR COVER
16
56
A--Gasket
E--Injection Pump Drive
H--Flange Nut M10 (4
B--Timing Gear Cover
Gear Cover Plate
Used)
C--Cap Screw M8 x 35 mm
F--O-Ring
I--Cap Screw M8 x 55 (2
(1 Used)
G--Cap Screw (2 Used
Used)
D--Cap Screw M8 x 40 mm
W/Aux Drive)(1 Used
J--Stud (4 Used)
K--Stud (2 Used)1
(10 Used W/Aux Drive)
W/O Aux Drive)
(6 Used W/O Aux Drive)
1. Make sure gasket surfaces on cover and front plate
3. Install timing gear cover (B) on engine.
are clean. See CLEAN AND INSPECT ENGINE
4. Apply LOCTITE 592 (TY9375) to cap screw (G)
FRONT PLATE, earlier in this group.
and torque timing cover cap screws and nuts to
2. Install injection pump drive gear cover plate (C)
specifications.
using a new O-ring (D), if necessary. Apply
LOCTITE 242 (T43512) to cap screws on rotary
Timing Gear Cover-to-Front Plate and Cylinder Block--
Specification
injection pump covers. Tighten screws to
specifications.
Torque....................................................................... 35 Nm (26 lb-ft)
Rotary Injection Pump Drive Gear Cover--Specification
Oil Pan-to-Timing Gear Cover--Specification
Torque........................................................................ 2 Nm (17 lb-in.)
Torque....................................................................... 35 Nm (26 lb-ft)
In-Line Injection Pump Drive Gear Cover--Specification
Torque........................................................................ 5 Nm (44 lb-in.)
LOCTITE is a trademark of Loctite Corp.
1
Serial Numbers: Dubuque-built engines (703905-- ), Saran-built
engines (516218-- ), Torreon-built engines (001000-- ).
Continued on next page
RG,16,DT7471 1914NOV971/5
13-288