TM 5-3805-280-24-2
Lubrication System
INSTALL OIL PAN
20
29
1. Apply LOCTITE 515 Flexible Form-In-Place Gasket on
oil pan rail as shown where flywheel housing, front
plate, and timing gear cover attach to cylinder block.
2. Install oil pan gasket.
3. Install oil pan and tighten cap screws to specifications.
M8 Cap Screws--Specification
Torque ............................................................................. 35 Nm (26 lb-ft)
M10 Cap Screws up to 110 mm--Specification
Torque ............................................................................. 70 Nm (52 lb-ft)
M10 Cap Screws 110 mm and Above--Specification
Torque ............................................................................. 60 Nm (44 lb-ft)
M10 Cap Screws on PE4045DLV50 and PE4045TLV50 Engines
Only--Specification
Torque ............................................................................. 44 Nm (33 lb-ft)
4. Install aluminum or copper washer on drain plug with
raised center against plug. Install plug in oil pan.
Tighten drain plug to specifications.
Plug for PE4045DLV50 and PE4045TLV50 Engines--Specification
Torque ............................................................................. 70 Nm (52 lb-ft)
Plug for Aluminum Oil Pans--Specification
Torque ............................................................................. 20 Nm (15 lb-ft)
Plug for All Other Engines--Specification
Torque ............................................................................. 47 Nm (35 lb-ft)
If equipped with elbow drain fittings, the threads and
sealing surfaces must be free of oil film to insure an
effective seal. Apply LOCTITE 592 Pipe Sealant with
TEFLON to fitting except for the leading one to three
threads. Install and tighten fitting.
LOCTITE is a registered trademark of the Loctite Corp.
TEFLON is a registered trademark of the DuPont Co.
Continued on next page
RG,20,DT7519 1917NOV971/2
13-322