Batteries, Support, and Cables
CAUTION: Battery gas can explode. Keep
sparks and flames away from batteries. Use a
flashlight to check battery electrolyte level.
Never check battery charge by placing a metal
Always remove grounded (-) battery clamp first
and replace it last.
IMPORTANT: Machine electrical system is 24-volt
negative (-) ground. Use only 24-volt
booster batteries Disconnect PVC and
monitor controller from harness in case
batteries are connected incorrectly.
2. Disconnect engine and pump controller and monitor
controller connectors and connect booster batteries (B)
to machine batteries (A) making the last connection at
machine frame, away from batteries.
Rock the clamps to make sure they make good
Booster Batteries, 2-Battery Application
When possible, use equipment with a switch in the
cable that connects booster batteries to machine
Continued on next page