TM 5-3805-281-24-2
Cylinder Block, Liners, Pistons, and Rods
IMPORTANT: Do not rotate crankshaft with cylinder
head removed unless liners are bolted
down. Bolt liners down before removing
piston.
Cap screws and washers must be
tightened to the above specification to
achieve an accurate reading when
measuring liner standout (height above
block). See MEASURE LINER
STANDOUT (HEIGHT ABOVE BLOCK),
later in this group.
4. Use 9/16-18 cap screws, approximately 51 mm
(2.0 in.) long and 5/8 in. I.D. 1-3/4 in. O.D. x 3.18 mm
(1/8 in.) thick washers to bolt down cylinder liners in
Bolting Down Cylinder Liners
the seven locations as shown. Tighten cap screws to
68 Nm (50 lb-ft).
Continued on next page
RG,RG34710,1113
1923OCT972/5
11-148