TM 5-3805-281-24-2
Cylinder Block, Liners, Pistons, and Rods
INSTALL CYLINDER LINER IN BLOCK
IMPORTANT: Install cylinder liners into same cylinder
block bore as removed.
DO NOT scuff the liner packing across
the upper counterbore.
Pitted or eroded liners that meet reuse
guidelines should be rotated 90 from
their removed position. (See VISUALLY
INSPECT CYLINDER LINERS earlier in
Installing Cylinder Liners in Block
this group for reuse guidelines.)
1. Install liner in block bore with manufacturing data code
(stamped on flange) toward front of engine, unless liner
O.D. is pitted or eroded.
If liner O.D. is pitted or eroded, but still within
acceptable service limits, rotate liner 90 from it's
removed position. Pitted sections of the liner should be
facing the front or rear of engine.
2. A resistance will be felt when cylinder liner is aligned in
pilot bore.
3. Using only the pressure of both palms, the cylinder
liner should drop to a point nearly flush with upper
flange of the cylinder liner and cylinder block.
Continued on next page
RG,RG34710,1140
1923OCT971/2
