TM 5-3805-281-24-2
Crankshaft, Main Bearings, and Flywheel
INSTALL FLYWHEEL
CAUTION: Flywheel is heavy. Plan a handling
procedure to avoid personal injuries.
Two guide studs may be used at cap screw locations (A)
opposite each other to aid in flywheel installation.
NOTE: ALWAYS use new cap screws when installing
flywheel. Flywheel must be clean and free of oil
before installing.
1. Coat threads of flywheel attaching cap screws with
LOCTITE 242 or its equivalent.
2. Position flywheel over dowel pin and install drive hub
Installing Flywheel
(if equipped). Start four cap screws. Remove guide
studs and install remaining cap screws.
3. Install remaining flywheel attaching cap screws.
4. Tighten flywheel attaching cap screws to 115 Nm (85
lb-ft).
LOCTITE is a trademark of Loctite Corp.
RG,RG34710,1191
1923OCT971/1
