TM 5-3805-281-24-2
Air Intake and Exhaust System
REPLACE CENTER HOUSING ASSEMBLY AND ASSEMBLE TURBOCHARGER
Turbocharger Assembly
A--Compressor Housing
C--Center Housing
D--Turbine Housing Clamp
E--Turbine Housing
B--Compressor Housing
Assembly
Plates
Clamp Plates
2. Lay turbine housing on outlet side and install center
IMPORTANT: ALWAYS use new cap screws when
housing assembly into turbine housing. Align
installing compressor and turbine
scribed reference marks (scribed during
housings onto center housing
disassembly) on turbine housing and center
assembly.
housing.
If reference index marks were not
3. Apply a coat of PT569 NEVER-SEEZ Compound
established during turbocharger
disassembly, tighten clamp cap
to new turbine housing cap screw. Install clamps
screws "finger-tight" until
(D) and cap screws. Tighten cap screws to
turbocharger is installed on engine
specification.
and housings are properly indexed
with air intake and exhaust piping.
4. Position compressor housing onto center housing
assembly. Align scribed reference marks (scribed
1. Carefully transfer the scribed marks from the
during disassembly) on compressor housing and
original center housing (C) to the replacement
center housing.
assembly, if necessary. Use the same procedure
for the turbine housing (E) and compressor housing
(A), if they are also being replaced.
NEVER-SEEZ is a trademark of Emhart Chemical Group.
Continued on next page
RG,RG34710,1265
1923OCT971/2