TM 5-3805-294-23-1
0036
Table 1. DTC 110.17 - Coolant Temperature Signal Slightly Low - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Visually inspect engine wiring
1.
If damaged or has loose
harness connector J03 for
sockets, replace engine wiring
damage and loose sockets.
harness. (Volume 4,
WP 0510) Restore machine to
original condition and operate
engine through normal speed
and load. (TM 5-3805-294-10)
(Volume 5, WP 0794) Clear
and refresh DTCs. (Volume 3,
WP 0362)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 9.
1.
Disconnect engine wiring
9.
Open Circuit
harness connector T04 from
Between Engine
engine coolant temperature
Wiring Harness
Connector J03
sensor. (Volume 5, WP 0800,
Socket D3 and
Figure 69)
Engine Wiring
Harness Connector
T04 Socket A.
2.
Measure resistance (Volume
1.
If less than 5 ohms, proceed to
Malfunction 10.
3, WP 0369) between engine
wiring harness connector J03
2.
If greater than 5 ohms, replace
socket D3 (Volume 5,
engine wiring harness.
WP 0800, Figure 48) and
(Volume 4, WP 0510) Restore
engine wiring harness
machine to original condition
connector T04 socket A.
and operate engine through
(Volume 5, WP 0800, Figure
normal speed and load. (TM
69)
5-3805-294-10) (Volume 5,
WP 0794) Clear and refresh
DTCs. (Volume 3, WP 0362)
Measure resistance (Volume
1.
If less than 5 ohms, proceed to
10.
Open Circuit
Malfunction 11.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J03
2.
If greater than 5 ohms, replace
Connector J03
socket H3 (Volume 5,
engine wiring harness.
Socket H3 and
WP 0800, Figure 48) and
(Volume 4, WP 0510) Restore
Engine Wiring
engine wiring harness
machine to original condition
Harness Connector
connector T04 socket B.
and operate engine through
T04 Socket B.
(Volume 5, WP 0800, Figure
normal speed and load. (TM
69)
5-3805-294-10) (Volume 5,
WP 0794) Clear and refresh
DTCs. (Volume 3, WP 0362)
0036-6