TM 5-3805-294-23-1
0047
Table 1. DTC 611.03 - Injector Shorted to Voltage Source - Continued.
Test or Inspection
Corrective Action
Malfunction
1.
Turn key switch to ON position,
4.
Short Circuit
but DO NOT START ENGINE
Between Electronic
(TM 5-3805-294-10). (Volume
Fuel Injector Wiring
Harness Connector
5, WP 0794)
C01 and Ground.
2.
Measure voltage (Volume 3,
WP 0369) between each pin
on electronic fuel injector
wiring harness connector C01
(Volume 5, WP 0800, Figure
32) and a known good ground.
Note reading.
3.
Turn key switch to OFF
1.
If all measurements were less
position (TM 5-3805-294-10).
than 0.5 volts, proceed to
Malfunction 5.
(Volume 5, WP 0794)
2.
If any measurement was
greater than 0.5 volts, replace
electronic fuel injector wiring
harness. (Volume 3,
WP 0409) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
1.
Disconnect engine wiring
5.
Engine Wiring
harness connector J01.
Harness Connector
J01 Has Damage or
(Volume 5, WP 0800, Figure
Loose Sockets.
46)
2.
Visually inspect engine wiring
1.
If damaged or has loose
harness connector J01 for
sockets, replace engine wiring
damage and loose sockets.
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 6.
0047-4