TM 5-3805-294-23-1
0047
Table 1. DTC 611.03 - Injector Shorted to Voltage Source - Continued.
Test or Inspection
Corrective Action
Malfunction
Measure resistance (Volume
1.
If less than 10 ohms, proceed
14.
Open Circuit
to Malfunction 15.
Between Engine
3, WP 0369) between engine
Wiring Harness
wiring harness connector J01
2.
If greater than 10 ohms,
Connector J01
socket F1 (Volume 5,
replace engine wiring
Socket F1 and
WP 0800, Figure 46) and
harness. (Volume 4,
Engine Wiring
engine wiring harness
WP 0510) Restore machine to
Harness Connector
connector C01 socket 11.
original condition and perform
C01 Socket 11.
(Volume 5, WP 0800, Figure
Harness Diagnostic Mode
32) Note reading.
Test. (Volume 3, WP 0345)
1.
Reconnect engine wiring
15.
Short Circuit
harness connector C01 to
Between Engine
electronic fuel injector wiring
Wiring Harness
harness connector C01.
Connector J01
Socket G1 and
(Volume 5, WP 0800, Figure
Ground.
32)
2.
Turn key switch to ON position,
but DO NOT START ENGINE
(TM 5-3805-294-10). (Volume
5, WP 0794)
3.
Measure voltage (Volume 3,
WP 0369) between engine
wiring harness connector J01
socket G1 (Volume 5,
WP 0800, Figure 46) and a
known good ground. Note
reading.
4.
Turn key switch to OFF
1.
If voltage is less than 0.5 volts,
position (TM 5-3805-294-10).
proceed to Malfunction 16.
(Volume 5, WP 0794)
If voltage is greater than 0.5
2.
volts, replace engine wiring
harness. (Volume 4,
WP 0510) Restore machine to
original condition and perform
Harness Diagnostic Mode
Test. (Volume 3, WP 0345)
1.
Turn key switch to ON position,
16.
Short Circuit
but DO NOT START ENGINE
Between Engine
(TM 5-3805-294-10). (Volume
Wiring Harness
Connector J01
5, WP 0794)
Socket G2 and
Ground.
0047-7