TM 5-3805-294-23-1
0129
Table 1. Glow Plug Check - Continued.
Test or Inspection
Corrective Action
Malfunction
3.
Visually inspect connector for
1.
If damaged or has loose
damage and loose sockets/
sockets/pins, replace monitor
pins.
controller wiring harness for
pin side of connector (Volume
4, WP 0519) or replace cab
wiring harness for socket side
of connector. (Volume 4,
WP 0504) Restore machine to
original condition.
2.
If not damaged and does not
have loose sockets/pins,
proceed to Malfunction 10.
Using a jumper wire, measure
1.
If continuity is present, replace
10.
Open Circuit
resistance (Volume 3,
monitor controller wiring
Between Connector
harness. (Volume 4,
X23 Socket 10 and
WP 0369) between connector
Engine Interface
X23 socket 10 (Volume 5,
WP 0519) Restore machine to
Wiring Harness
original condition.
WP 0800, Figure 90) and
Connector J02
engine interface wiring
2.
If continuity is not present,
Socket C2.
harness connector J02 socket
proceed to Malfunction 11.
C2. (Volume 5, WP 0800,
Figure 47) Note reading.
1.
Remove engine compartment
11.
Connector H01 Has
lower access cover. (Volume
Damage or Loose
Sockets/Pins.
4, WP 0593)
2.
Disconnect connector H01.
(Volume 5, WP 0800, Figure
40)
3.
Visually inspect connector H01
1.
If damaged or has loose
for damage and loose sockets/
sockets, repair connector H01
pins.
(Volume 4, WP 0511) or
replace engine interface wiring
harness. (Volume 4,
WP 0509) Restore machine to
original condition.
If damaged or has loose pins,
2.
replace machine wiring
harness. (Volume 4,
WP 0516) Restore machine to
original condition.
3.
If not damaged and does not
have loose sockets/pins,
proceed to Malfunction 12.
0129-5