TM 5-3805-294-23-1
0129
Table 1. Glow Plug Check - Continued.
Test or Inspection
Corrective Action
Malfunction
2.
Visually inspect glow plug
1.
If damaged or has loose
wiring harness connectors R1
sockets, replace glow plugs
- R6 for damage and loose
wiring harness. (Volume 3,
sockets.
WP 0432) Restore machine to
original condition.
2.
If not damaged and does not
have loose sockets, proceed to
Malfunction 18.
Using a jumper wire, measure
1.
If less than 10 ohms, proceed
18.
Open Circuit
resistance (Volume 3,
to Malfunction 21.
Between Relay K16
Wire Terminal P05
WP 0369) between relay K16
2.
If greater than 10 ohms,
and Glow Plug
wire terminal P05 (Volume 5,
proceed to Malfunction 19.
Connectors R1 - R6.
WP 0800, Figure 208) and
glow plug terminals R1 - R6.
(Volume 5, WP 0800, Figure
85) Note readings.
1.
Disconnect engine interface
19.
Engine Interface
wiring harness connector R0
Wiring Harness
from glow plug wiring
Connector R0 Has
harness. (Volume 5,
Damage or a Loose
Socket/Pin.
WP 0800, Figure 230)
2.
Visually inspect connector R0
1.
If damaged or has a loose
for damage and loose sockets/
socket/pin, repair connector
pins.
R0, (Volume 4, WP 0511) or
replace engine interface wiring
harness for socket side of
connector, (Volume 4,
WP 0509) or replace glow plug
wiring harness for pin side of
connector. (Volume 4,
WP 0614) Restore machine to
original condition.
2.
If not damaged and does not
have a loose socket/pin,
proceed to Malfunction 20.
0129-8