TM 5-3805-294-23-1
0129
Table 1. Glow Plug Check - Continued.
Test or Inspection
Corrective Action
Malfunction
Using a jumper wire, measure
1.
If continuity is present, replace
12.
Open Circuit
resistance (Volume 3,
engine interface wiring
Between Connector
harness. (Volume 4,
X23 Socket 10 and
WP 0369) between connector
Connector H01 Pin
X23 socket 10 (Volume 5,
WP 0509) Restore machine to
6.
original condition.
WP 0800, Figure 90) and
connector H01 pin 6. (Volume
2.
If continuity is not present,
5, WP 0800, Figure 40) Note
proceed to Malfunction 13.
reading.
1.
Remove center top cover.
13.
Connector X4 Has
Damage or Loose
(Volume 4, WP 0589)
Sockets/Pins.
2.
Disconnect the following:
a. Connector X3. (Volume
5, WP 0800, Figure 84)
b. Connector X4. (Volume
5, WP 0800, Figure 85)
c. Connector X41.
(Volume 5, WP 0800,
Figure 102)
d. Connector X42.
(Volume 5, WP 0800,
Figure 103)
3.
Unmount and reposition the
cab wiring harness connectors
for service. (Volume 3,
WP 0312)
4.
Visually inspect connector X4
1.
If damaged or has loose
for damage and loose sockets/
sockets/pins, replace cab
pins.
wiring harness for socket side
of connector (Volume 4,
WP 0504) or replace machine
wiring harness for pin side of
connector. (Volume 4,
WP 0516) Restore machine to
original condition.
2.
If not damaged and does not
have loose sockets/pins,
proceed to Malfunction 14.
0129-6