TM 5-2420-230-24-1
Input Shaft Seal Replacement - M110P2
IMPORTANT:
Removal of the steering gear is required before input shaft seal replacement can be
performed.
After you have removed the steering gear from the chassis, it is important that you follow the disassembly pro-
cedures in the "Disassembly" section of the manual. After the bearing cap assembly has been removed from
the steering gear, you may proceed with changing the input shaft seal.
TOOLS REQUIRED:
Small hammer
Sharp chisel
Sheppard tool #3563992
Sheppard tool #3563982
Bench vise
0-150 in/lb dial-type torque wrench
0-150 ft/lb torque wrench
Assorted sized sockets
Small screwdriver
PARTS REQUIRED:
5541421-Seal Kit
5541411-Seal Kit
ADDITIONAL REFERENCES:
Vehicle Manufacturer's Service Manual
R.H. Sheppard Co. Maintenance & Troubleshooting Video
Directions Supplied in Seal Kit
PROCEDURE:
1.
With a small screwdriver, remove the bearing
cap plunger (Figure 61).
Figure 61
K-63